Different operational objectives, such as cutting and rough machining, can be achieved through different equipment and machinery, irrespective of the process operation. Granulator cutter For the fine granulator cutter group of the production line to achieve the ideal cutting effect, the following aspects are indispensable, and we can also take these as the main direction for cutting process improvement. Today, let's look at the control variable method of the granulator cutter.

　　First, continuous cutting must be achieved, that is, using the speed ratio between the fixed passes of the granulator cutter, continuous cutting is achieved through single-line micro-tension, no-twist, high-speed mode; second, strictly control the temperature, using the granulator cutter water-cooling method to control the workpiece deformation temperature, avoiding undesirable phenomena. To meet the requirements of high precision, the design of the workpiece should be reasonable, and the size calculation should be accurate, so as to reduce the error to the minimum range. The quality design of the granulator cutter explosion ghost in the granulator cutter group is relatively small to meet the cutting requirements of various specifications and expand its application range.

　　During a thorough inspection of the granulator cutter, it was found that its screws were misaligned, which directly affects the stability of the granulator cutter and must be repaired as soon as possible. The specific operation steps are as follows.

　　The granulator cutter is fixed to the cement foundation with foundation bolts. When repairing the misalignment, the foundation bolt cement foundation should first be filled with cement mortar, and then the two misaligned foundation bolts on the granulator cutter should be cut along the cement base; in addition, two bell-shaped fixing screws were also processed. In this process, it should be noted that the upper and lower positions cannot be fixed when preventing adhesion.

　　Then clean the processed screws, and then use the prepared adhesive to bond the crank bolts to the original foundation bolts. At this time, it is necessary to adjust their positions appropriately so that the bonding parts can be baked with an infrared lamp to solidify the adhesive and achieve the required bonding arc. The repaired screws will have a trial period. If the granulator cutter has no problems during this period, the repair is successful.