After purchasing, you must carefully read Granulator Cutter the installation instructions and install according to the instructions. Check if all parts' fastening nuts and safety covers are loose. Manually move the counting wheel or V-belt pulley to check if the transmission system is normal. Check if the granulator cutter electrical cabinet has ground protection, emergency stop button, and whether the position and operation are correct. Test whether the power, water, compressed air, heating, and cooling systems are connected and leak-free. Ensure the granulator cutter meets the product thickness requirements, adjust the die gap appropriately, and use a feeler gauge to check for uniform gaps and secure the screws. The temperature rise of the head and the barrel occur simultaneously.

　　Regularly check if the safety devices of the granulator cutter are functioning properly and effectively, especially after changing the mold. Check if the mechanical insurance has been adjusted accordingly. Regularly check the grounding, insulation, and aging of the electrical components.

　　The granulator cutter has a certain amount of creep before starting. Below, we introduce the follow-up work of the granulator cutter:

　　1. At the end of work, the inside of the granulator cutter must be cleaned to prevent rust and blockage of the screen. The open space must be waterproof and fireproof.

　　2. Those who do not understand the operating requirements of the granulator cutter are not allowed to work alone.

　　3. The bag is made of breathable sparse cotton cloth, with a diameter of 500mm and a length of 3.4-4m.

　　4. Working alone is prohibited after drinking alcohol, illness, or fatigue.

　　5. When the granulator cutter is working, a belt air hood should be installed to ensure personal safety.

　　6. After the machine has been working for 200 hours, the wear of the rotating shaft should be checked. If the wear is serious, it should be replaced immediately to avoid serious damage.